Description
1/8 DIN panel mount pH/ORP controller with dual SPDT Hi/Lo relays, manual set points and calibration are via potentiometers. Features a voltage/recorder output and an internal pH/ORP select switch. Display is a large bright red LED. Connectors are a BNC input and spade lug screw type connector block. Meter requires a Pt-100 ATC or a simulation resistor for temperature. Power115/230A AC.
- All solid state design
- Low cost
- Easy to install
- Set points on front panel
- Recorder output
- 0.56 high efficiency red led display
- 1/8 DIN aluminum case
- Set points cover entire span
- ATC for pH 0 to 100 °C
- Internal pH/ORP select switch
- Low power consumption design, reduced internal heating thus increased reliability